Scutching

 ( Cotton Production ) 

Scutching is a step in the processing of cotton or the dressing of flax or hemp in preparation for spinning. The scutching process separates the impurities from the raw material, such as the Cotton gin or the straw and woody stem from flax fibers."Scutch." The Oxford English Dictionary. 2nd ed. 1989. Scutching can be done by hand or by a machine known as a scutcher. Hand scutching of flax is done with a wooden scutching knife and a small iron . The end products of scutching flax are the long finer flax fibers called line, short coarser fibers called tow, and waste woody matter called shives.

In the early days of the cotton industry, the raw material was manually beaten with sticks after being placed on a mesh, a process known as willowing or batting. The task was mechanised by the development of machines known as willowers. Scutching machines were introduced in the early 19th century. These processed the raw material into a continuous sheet of cotton wadding known as a lap.

---

Cotton scutching Before cotton is processed, it has to be cleaned of its Cottonseed and other impurities. In the early days, this was done by spreading the raw cotton on a mesh and beating it by hand with sticks, a process known as willowing or batting. A scutching machine for cotton (known as a scutcher) was invented in 1797, but did not get much attention until it was introduced in the of Manchester in 1808 or '09. By 1816, scutchers had been generally adopted.

The scutching machine passes the cotton through a pair of rollers, then strikes it with iron or steel bars, called beaters. The rapidly turning beaters strike the cotton hard and knock the seeds out. This process is done over a series of parallel bars, allowing the seeds to fall through. At the same time, air is blown across the bars, which carries the cotton into a cotton chamber. The end result is a continuous sheet of cotton wadding known as a lap, ready for the next stage of the production process, known as carding.

---

Flax scutching

---

By hand To scutch flax by hand, the scutching knife is scraped down with a sharp strike against the fibers while they hang vertically. The edge of the knife is scraped along the fibers to pull away pieces of the stalk. This is repeated until all of the stalk has been removed and the flax is smooth and silky. When scutching was done by hand, people could scutch up to of flax in one day, depending on the quality of the flax, as coarser flax, harder flax, and poorly retting flax takes longer to scutch. Retting removes the that bind the fibers to the stalk and each other, so under-retted flax is harder to separate from the stalk, and often gets damaged in the scutching process. Over-retting the flax causes the fibers to deteriorate and break. These broken fibres are called codilla, which can be used along with heckled tow to make yarn.

In the scutching process, some of the fiber is also scutched away along with the stalk, a normal part of the process.

---

By machine

Scutching is done several ways by machine. Scutching mills started in Ireland, and were commonly used there by 1850, at a time when hand scutching was still common in Continental Europe. Machine scutching, while faster and cheaper, causes more waste than scutching by hand. One method of machine scutching is to crush the stalks between two metal rollers so that parts of the stalk can be separated.

A modern scutching machine can process up to of flax every hour, and produces about of flax fibers and of tow (fibre). Older machines create more waste.

---

See also

Notes

Bibliography

Categories: Cotton Production, Flax, Hemp, Articles Containing Video Clips

Post Comment