A penstock is a sluice or floodgate or intake structure that controls water flow, or an enclosed pipe that delivers water to
Hydroelectric systems and dams
Penstocks for
hydroelectric installations are normally equipped with a gate system and a
surge tank. They can be a combination of many components such as anchor block, drain valve, air bleed valve, and support piers depending on the application.
Flow is regulated to suit
turbine operation and is cut off when turbines are not in service. Penstocks, particularly where used in polluted water systems, need to be maintained by hot water washing, manual cleaning,
antifouling coatings, allowing waters to go , and
desiccation used to dry fouling out so that it may slough off or become easier to remove through manual processes.
The term is also used in irrigation dams to refer to the channels leading to and from high-pressure sluice gates.
Penstocks are also used in mine tailings dam construction. The penstock is usually situated fairly close to the center of the tailings dam and built up using penstock rings, short reinforced ring-like sections of pipe which nest one within the other when stacked and thereby control the water level, letting the biofilm settle out of the water. This water is then piped under the tailings dam back to the plant via a penstock pipeline.
Watermills
Inlet valves on the downstream end of penstocks are often used at mill sites to control the flow of water through the mill wheel, or to pen water into a mill pool.
Similar structures
Similar structures which are not enclosed are
head races or
(non elevated), and
(elevated).
Hydraulics
Penstocks are commonly used in water management systems such as surface water drainage and foul water sewers. Penstocks provide a means of isolation of flows and regulate the flow of water while delivering it to waste management facilities or power plants.
Landfills
Penstocks are incorporated into the surface water management systems (drainage) of many landfill sites.
are constructed in order to store storm water, limiting the discharge from the site to its pre-development rate. Valved penstocks are installed at the outfall of the basin to isolate potentially contaminated surface waters from discharging into a main watercourse.
External links
