Product Code Database
This is a high-speed and low-cost hardware debugger/programmer. It can be used for in-circuit debugging logic incorporated into each chip with Flash memory. Features: Minimum of additional hardware needed for debug Expensive sockets or adapters are not required. The PICkit 3 can now also reprogram any PIC microcontroller. Note: The PICkit 3 In-Circuit Debugger/Programmer is NOT a production programmer. It should be used for development purposes only. Supports low voltage to 2.0 volts (2.0v to 6.0v range) Diagnostic LEDs (power, busy, error) Read/write program and data memory of microcontroller Erase of program memory space with verification Freeze-peripherals at breakpoint USB (High speed 12 Mbits/s interface to host PC) Real-time execution MPLAB IDE compatible (free copy included) Built-in over-voltage/short circuit monitor Firmware upgradeable from PC/web download Totally enclosed The MPLAB PICkit 3 allows debugging and programming of PIC and dsPIC Flash microcontrollers at a reasonable price point using the powerful graphical user interface of the MPLAB Integrated Development Environment (IDE). The MPLAB PICkit 3 is connected to the design engineer's PC using a high speed USB interface and can be connected to the target via an Microchip debug (RJ-11) connector (compatible with MPLAB ICD 2, MPLAB ICD 3 and MPLAB REAL ICE). The connector uses two device I/O pins and the reset line to implement in-circuit debugging and In-Circuit Serial Programming. Features: Minimum of additional hardware needed for debug Expensive sockets or adapters are not required. The PICkit 3 can now also reprogram any PIC microcontroller. Note: The PICkit 3 In-Circuit Debugger/Programmer is NOT a production programmer. It should be used for development purposes only. USB (High speed 12 Mbits/s interface to host PC) Real-time execution MPLAB IDE compatible (free copy included) Built-in over-voltage/short circuit monitor Firmware upgradeable from PC/web download Totally enclosed Supports low voltage to 2.0 volts (2.0v to 6.0v range) Diagnostic LEDs (power, busy, error) Read/write program and data memory of microcontroller Erase of program memory space with verification Freeze-peripherals at breakpoint Program up to 512K byte flash with the Programmer-to-Go Package includes: One PIC kit3 programmer One red USB cable One 6-pin ICSP cable Two 6-pin double-headed Pin One Universal 40-pin ZIF Socket One offline power supply (INPUT: 100-240VAC 50/60Hz; OUTPUT: DC5V 1300mA) One DVD disk
|
