Reduces sand, silt, scale, and rust particles in residential, commercial, and municipal drinking water Combines two separate gradient layers for higher efficiency and dirt-loading capacity Spun polypropylene for resistance to chemicals and bacteria Initial pressure drop of less than 1 psi at a flow rate of 10 gpm Temperature range of 40 to 145 degrees F (4.4 to 62.8 degrees C). This Pentek DGD-5005 spun polypropylene filter cartridge reduces sand, silt, scale, and rust particles in residential, commercial, and municipal drinking water. It has two separate gradient layers for higher particle reduction efficiency and dirt-loading capacity than standard spun or string-wound cartridges. The nominal filtration rating of the pre-filter layer is 50 microns, and the rating of the post-filter layer is 5 microns. The filter is made of spun polypropylene fibers for resistance to chemicals and bacteria. It has an initial pressure drop of less than 1 pound per square inch (psi) at a flow rate of 10 gallons per minute (gpm), and operates over a temperature range of 40 to 145 degrees F (4.4 to 62.8 degrees C). This spun polypropylene filter cartridge meets National Sanitation Foundation/American National Standards Institute (NSF/ANSI) standard 42 for quality assurance, and is used for treatment of residential, commercial, and municipal drinking water.Specifications
After searching many sites and coming up with the filter I wanted to use on my newly self installed GE GXWH40L whole house filter, I came here to Amazon to find the best pricing for filters. I installed the filter setup before the water softener. We are on a community pump station (Aqua Texas) that pulls the water from the Trinity Aquifer. I never realized how much sediment/rust was in our water. Within two hours the filter was already changing from..
