Atdec Ac-ap-2010 Visidec Adapter Plate - Mounting Kit (conversion Plate) - Black - Mounting Interface: 200 X 100 Mm - For Spacedec Sd-pos-ha Sd-pos-vbm-b2b Vi available on April 21 2018 from PCMall for 24.99
Atdec AC-AP-2010 Adapter Plate Mounting Kit - For Flat Panel Display - Steel - Black available on September 22 2016 from Buy for 39
Atdec Mount Ac-ap-2010 Accessory Mount Converts Atdec 75 X 75 Mounts Up To Vesa 200 X 100 available on May 24 2016 from Newegg for 16.39
Atdec Adapter Plate 200mm x 100mm VESA available on November 30 2014 from Amazon for $19.52
UPC bar code 881493004948 ξ3 registered April 21 2018
UPC bar code 881493004948 ξ4 registered September 22 2016
UPC bar code 881493004948 ξ5 registered May 24 2016
UPC bar code 881493004948 ξ1 registered September 12 2015
UPC bar code 881493004948 ξ2 registered November 30 2014
Product category is Mounting Kits Electronic Monitor
I have a Samsung monitor that, for some unexplained reason, decided to recess their VESA mount in the back of the monitor. This adapter plate was rather nice but did not fit inside of the recess. I had to spend some quality time with it and a reciprocating saw to finally trim off some of the rounded edges. Aside from it not fitting in the odd design of my monitor, the product itself was great.
I needed a 200mm x 100mm adapter for the HP2710M monitors I purchased ("Famous Maker"... you know). These are a stamped steel heavy-duty one-piece solution for this "goofy" non-square mount. There are several things you should consider about this mount BEFORE you buy one:1. This adapter does NOT fit within the confines of the recessed area on the rear of the monitor that contains the mounting holes. The rounded edges overlap the recess. This in itself is not a real problem as surface area of contact is..
The first review on this product -- where the author indicates that this adapter works with the Samsung 2494 -- monitors is dead wrong. I purchased three of these adapters based on that review (I have three Samsung 2494HM monitors). The adapter is too large to fit in the recessed space on the back of the Samsung monitor. In order for it to fit properly, you'd have to either carve out plastic on the monitor, use a grinder and grind down the corners of the adapter, or get longer screws.In short, if you have a..