MPQ4754: Features: -Above ground insulation piercing connectors.-Made from high - strength fiber - reinforced thermoplastic and galvanized steel bolts.-Installs in just minutes saving many man - hours on the job.-Eliminates wire stripping, connecting and taping of split bolts and adding inhibitor.-Above ground connector can be installed on energized circuits eliminating power shutdowns.-Overhead services - both insulated and bare mains, above grade URD services, street lighting
Above ground insulation piercing connectors. Made from high strength fiber reinforced thermoplastic and galvanized steel bolts. Installs in just minutes saving many man hours on the job. Eliminates wire stripping, connecting and taping of split bolts and adding inhibitor. Above ground connector can be installed on energized circuits eliminating power shutdowns. Overhead services both insulated and bare mains, above grade URD services, street lighting, non tension splicing and tapping. Insulated replacement for split bolts, tapping without cutting the main, gutter taps. Double shear head bolt guarantees correct torque tightening every time, ensuring a quality connection and eliminating the possibility of hot spots, damaged wires or loose connections. No cable stripping required, simply insert the jacketed cable into the entry port and tighten with a 0.5 6 point socket. Bolt and all external parts of the connector are completely isolated from energized parts and the bolt is covered by the plastic shear head. Installer has no contact at any point with an energized part. Can be installed on energized conductors, however, the tap must not be under load. Corrosion free connection is good for hot, cold, damp and salty connections. Properly installed the connector seals water tight. Accomplished by a sealant tank, that during installation is compressed and forces sealant out to protect the connection from oxygen and water. Copper teeth are tin plated, shell is high strength UV resistant thermoplastic insulating material, steel bolts are galvanized. UL486B Listed for cu to cu, al to al and cu to al. Meets ANSI C119.4 requirements. Number of ports: 1. Torque / Inch lb.: 80. Bolt head size: 0.5. Main range: 750 3/0. Tap range: 10 14. Box quantity: 12. Specifications: 600 Volt 194 F (90 C) rated. Dimensions: Dimensions: 4.3 H x 2.4 W x 2.8'' D.