CO2/YAG Laser Power Meter Probe 100 watts for Laser Engraving Cutting Machines (10.6 to 1.06 microns) available on March 20 2015 from Amazon for 95.00
UPC bar code 010013100222 ξ1 registered March 20 2015
Product category is Electronic Power
Manufacturered by Mahoney International
Product weight is 1.32 lbs.
The power meter probe can easily pay for itself with just one or several uses. Examples include: (1) Receive in-warranty replacement of bad glass CO2 laser tubes from Chinese laser machine manufacturer. (2) Note laser tube degradation over time to adjust laser machine power settings to ensure laserable materials are not ruined. Measures laser power for YAG (900-1250 nm) and CO2 (8-11 microns). Works for laser technologies including CO2 lasers, fiber lasers, YAG lamp lasers, diode end pumped lasers, and diode side pumped lasers. Each probe is fully tested, calibrated, and each probe has an engraved serial number. Comes with instructions and convenient storage container. 100 Watt CO2 Laser Power Measurement Probe. This product is great for owners of laser engraving machines, laser engraving systems, laser cutting machines, laser cutting systems. Also for owners of CO2 glass tube lasers, CO2 and YAG laser markers, laser marking machines, fiber laser marking machines. It even works with RF lasers manufactured by Synrad, Coherent, Rofin, Universal Laser, Epilog Laser, Universal Laser Systems, Gravograph, Pinnacle, RECI, EFR, Jilin Yong Li, Mactron Technology, North Star Electron, Shanghai Jinke Intelligent Technology, YL Lasers, Prima, Trumpf, PRC laser. It works with laser machines made by Rabbit Laser, GW Weike, Yueming, Hans Laser, Beijing New Power, Chutian, Foshan Beyond, Grand Bird, Jinan XYZ, Perfect laser, Suke, and many many more. Get your quick laser power output reading today and exercise your warranty as needed. Ensure the best quality for the laser cutting and engraving now. Do not miss this opportunity for our introductory pricing on Amazon. Laser power measurements are quick and easy with the 100 watt power probe. Position the power meter in front of the laser beam (as shown in the photo) and 30 seconds later read the power measurement. It does not involve a time consuming setup and alignment like other power meters. Unfortunately, most laser power meters have sacrificed ease of use to gain continuous power readings. However, in most laboratory and production situations, the usual requirement is for a quick spot-check of power with a minimum of disruption. This power probe will display the average power absorbed on the calibrated readout scale and can be used with continuous or repetitively pulsed lasers. Key Features are: 1. The absorbing probe head is conveniently sized. 2. The head is large enough to be easily used, yet small enough to be inserted between optical components to measure the laser power without disturbing set-up. 3. The hand-held meter requires only about one minute to make a laser power measurement 4. The absorbent coating is very tough, resisting mechanical abrasion and water immersion 5. A zero adjustment mechanism has been incorporated into the design to expedite and simplify the power measurement process 6. An accurate and durable all metal construction has been used to ensure a long life Taking Measurements The 100 watt power probe is a self-contained unit consisting of an absorbing head, a temperature measuring mechanism, a zeroing screw/nut and a readout dial. In operation, the dial is zeroed. Then, the absorbing head on the end of the power probe is exposed to the laser beam for 30 seconds. After the laser probe is removed from the laser beam, the average power can be read out on the dial. If it is necessary to make several power measurements in succession, the absorbing head can be rapidly cooled by immersing into a bucket of water between measurements. The 100 watt laser probe has a coating that works for the wavelength range of 0.2 to 11 microns.